SKU: TH2084
Sold Out!
We will notify you when this item is back in stock. Please enter your email.
MAX31850K 1-Wire Thermocouple Amplifier Breakout makes it easy to read high-temperature measurements from a K-type thermocouple only using a single 1-Wire data bus. It handles cold-junction compensation and thermocouple-to-digital conversion on-board, so your microcontroller can read temperature data without needing complex analogue front-end design.
This breakout is ideal when you want to connect one or many thermocouples to a single microcontroller pin with 1-Wire support. The MAX31850K output format is similar to the popular DS18B20 family, but it is not drop-in compatible without code changes because it uses a different 1-Wire family type.
The board arrives assembled and tested with a 3.3V regulator, bypass capacitors, a pre-soldered 2-pin thermocouple terminal block, pull-up resistor, and header pins. It supports both parasitic power and external power operation. Important: the data line is 3V only and must be level shifted when used with 5V microcontrollers.
Technical details for MAX31850K 1-Wire Thermocouple Amplifier Breakout.
| Specification | Details |
|---|---|
| Sensor Interface | 1-Wire |
| Thermocouple Type | K-type only |
| Measurement Range | -270°C to +1370°C |
| Resolution | 0.25°C thermocouple output increments |
| Cold-Junction Reading | Internal temperature reading supported |
| Supply Input | 3.3V to 5V via VIN, or parasitic power over data line |
| Data Logic Level | Approximately 3.3V only; not 5V tolerant |
| Onboard Regulator Output | 3.3V output available when externally powered, up to 100mA |
| Multi-Drop Support | Multiple MAX31850K boards can share one 1-Wire bus |
| Pin | Type | Description |
|---|---|---|
| VIN | Power input | 3.3V to 5V supply input when using external power |
| GND | Ground | Common ground for power and 1-Wire data reference; required even in parasitic mode |
| 3V3 | Power output | 3.3V output from onboard regulator when externally powered; unused in parasitic mode |
| DQ | Data | 1-Wire data line, 3V logic only; level shifting required for 5V hosts |
| A0-A3 | Address/config | Readable address pins for board identification; do not change the factory 64-bit 1-Wire ROM address |
| Thermocouple Terminal | Input | 2-pin screw terminal for connecting a K-type thermocouple |
Average rating
Based on 0 reviews
No reviews match this filter yet.
